Use and Care Manual

TO TURN UNIT ON OR OFF:
Press ON/OFF button to turn unit on or o .
NOTE: The unit will automatically initiate the Energy
Saver function under Cool, Dry, Auto (only Auto-
Cooling and Auto-Fan) modes.
TO CHANGE TEMPERATURE SETTING:
Press UP/DOWN button to change temperature setting.
NOTE: Press or hold either UP (
) or DOWN ( ) button
until the desired temperature is seen on the display.
This temperature will be automatically maintained
anywhere between 62°F (17°C) and 86°F (30°C). If
you want to display the actual room temperature,
see To Operate on Fan Only section.
TO ADJUST FAN SPEEDS:
Press to select the Fan Speed in four steps - Auto,
Low, Med or High. Each time the button is pressed,
the fan speed mode is changed. On Dry mode, the
fan operates on Low speed automatically.
SLEEP FEATURE:
Press Sleep button to initiate the sleep mode.
In this mode the selected temperature will
increase by 2°F/ 1(or 2)°C 30 minutes after the
mode is selected.
The temperature will then increase by another
2°F/ 1(or 2)°C after an additional 30 minutes.
This new temperature will be maintained
for 6 hours before it returns to the originally
selected temperature. This ends the Sleep
Key Pad Features
Energy
Saver
LED
Display
Clean
Filter
Operating
Instructions
mode and the unit will continue to operate
as originally programmed. The Sleep mode
program can be cancelled at any time during
operation by pressing the Sleep button again.
CHECK FILTER FEATURE:
Press Check  lter button to initiate this feature.
This feature is a reminder to clean the Air Filter
for more e cient operation. The LED (light) will
illuminate after 250 hours of operation. To reset
after cleaning the  lter, press the Check Filter
button and the light will go o .
ENERGY SAVER FEATURE:
Press Energy Saver button to initiate this
function. This function is available on COOL,
DRY, AUTO (only AUTO-COOLING and AUTO-
FAN) modes. The fan will continue to run for
3 minutes after the compressor shuts off.
The fan then cycles on for 2 minutes at 10
minute intervals until the room temperature is
above the set temperature, at which time the
compressor turns back on and Cooling resumes.
TO SELECT THE OPERATING MODE:
To choose operating mode, press Mode button.
Each time you press the button, a mode is
selected in a sequence that goes from Auto,
Cool, Dry and Fan. The indicator light adjacent
will be illuminate and remain on once the mode
is selected.
The unit will automatically initiate the Energy
Saver function under Cool, Dry, Auto (only Auto-
Cooling and Auto-Fan) modes.
Timer
Button
Power
Button
Sleep
Button
Fan
Button
Up (
) and Down ( )
Buttons
Mode
Button
Wi-Fi Indicator Light
(Wi-Fi models only)
Page 10 User Manual
CONNECT