Use and Care Manual

User Manual Page 17
6. Install R1 Hardware (only by applicable to Energy Star models)
In order to minimize air leaks and ensure optimal insulation, it is
necessary to install the included R1 hardware to the side curtain.
Follow the instructions below.
Step 1.
After the unit is installed in the window, measure the inner width of
the side curtain as shown (Fig. 11).
Measure the inner width
of the side curtain
Fig.11
Fig. 11
Fig. 12
or
Fig. 13
Step 2.
Mark a line on the provided R1 insulation panel that is 1/8” (3 mm)
less than the measured width in step 1, then cut the R1 insulation
panel along the line (Fig. 12).
Step 3.
Slide the R1 insulation panel into the side curtain. The side with
the pattern should facing indoors. (Fig. 13).
Step 4.
Repeat on the other side.
Installation
Instructions