User Guide

4.8 Display Mask 4 Replacement Procedures
4.8 Display Mask
Removing the Display Mask
Remove the display mask according to the following procedures and Figure 4-22.
1. Remove the six seals for covering the screws.
2. Remove the two M2.5x6 black flat-head screws and four white flat-head screws.
NOTE: When removing the screws, support the display by its back with one hand.
3. Release the following 20 latches on the display mask, in that order:
- Eight bottom latches
- Four latches on each of the left and right sides
- Four top latches
Seal for covering the screw
Latch
M2x6 white flat-head screw
Display mask
M2.5x6 black bind screw
Seal for covering the screw
Double side tape
Figure 4-22 Removing the display mask
Satellite M20 Maintenance Manual 4-33