User Guide

4.20 Toshiba 14.1-inch FL 4 Replacement Procedures
11. Remove the cell of the PCB assembly from the backlight assembly, as indicated by ①
in Figure 4-54. Completely remove the double-sided tape remaining on the reverse side
of the cell.
CAUTION: On the cell, three areas are bonded to the frame with the double-sided tape (as
shown in Figure 4-54, one area is at the top, and two areas are at the bottom of both sides).
Remove the cell gently, taking care not to damage it.
Use care not to peel off the masking tape in the three areas on the cell.
セルをはずす．
両面テープ３箇所はがしながら
1
Remove the cell by peeling off the three
pieces of double-sided tape.
Figure 4-54 Removing the cell of the PCB assembly
Satellite M20 Maintenance Manual 4-73