User Guide

4.20 Toshiba 14.1-inch FL 4 Replacement Procedures
17. Fold down the TAB (X-PCB) toward the reverse side of the backlight unit, as shown in
Figure 4-58.
CAUTION: Use care not to damage the TAB.
1
ＸＰＣＢを裏面に折り曲げ．
For the X-PCB toward the reverse side.
Figure 4-58 Folding down the TAB
18. Start installing the bezel in the upward direction until it stops at the top left corner.
NOTE: The GND-CU and lamp reflector on the left-hand side must not go beyond the
edges of the bezel.
Use care not to damage the cables and TAB.
The bezel latches must be engaged (there are five latches on the top edge, and two latches
on the bottom edge).
Satellite M20 Maintenance Manual 4-77