User Guide

4 Replacement Procedures 4.20 Toshiba 14.1-inch FL
ラッチ２箇所有り．
ラッチ５か所をはめる．
次にたＴＡＢ側をはめる．
ケーブルをキズつけないように注意
ベゼルをランプ側からはめる．
ベゼルの外に出ないこと．
ＧＮＤ－ＣＵ折り曲げ有り．
ベゼルの外に出ないこと
リフレクタ折り曲げ有り．
2
2
2
2
2
1
Next, fit the bezel’s edge close to the TAB.
Close the five latches.
First, fit the bezel’s edge close to the lamp.
Use care not to dama
g
e the cable.
The fold of GND-cu must not go
beyond the bezel’s edge.
The fold of reflector must not go
beyond the bezel’s edge.
Two latches
Figure 4-59 Aligning the bezel
19. Fasten the four screws on the left edge in the order ⑤, ⑥, ⑦, and ⑧ shown in Figure
4-59.
20. Fasten the four screws on the right edge in the order ①, ②, ③, and ④ shown in Figure
4-59.
CAUTION: Fasten the screws in the orders shown in Figure 4-60. No loose fastening is
allowed.
The tightening torque must not exceed 0.147 Ｎ･ m (1.5kgf ･ cm) for all the eight screws.
For the Philips screwdrivers, use an insert bit of point size 0.
4-78 Satellite M20 Maintenance Manual