User Guide

4.21 Sharp 14.1-inch FL 4 Replacement Procedures
4. Using the U-shaped edge of the bezel as a "hinge," raise the edge of the bezel from which the clips have
been removed. Then remove the bezel. Peel off the tape for GND wire fixing (J).
U-shaped edge
of the bezel
Tape for ground
wire fixing (J)
Figure 4-65 Removing the bezel
5. Flip the bezel over and remove the two screws (E) and lamp cover (F). Then replace the
lamp unit (G) with a new one.
Maximum allowed
releasing torque is
0.1078N
･
m (1.1kgf
･
cm).
Figure 4-66 Removing the lamp cover
Satellite M20 Maintenance Manual 4-83