User Guide

4 Replacement Procedures 4.21 Sharp 14.1-inch FL

6. Attach the lamp cover (F) and attach the shield tape to the lamp cover after folding it.

Then fix the lamp cover with the two screws (E).

The attached lamp cover must not cover the heads of the engaging pins.

Around the opening for extracting the lead, the edge of the P chassis should go beyond

the edge of lamp cover.

Maximum allowed tightening torque is

0.1176N

･

m (1.2kgf

･

cm).

Engaging pin

Fold here

Figure 4-67 Replacing the lamp unit

7. Fix the GND lead with the tape.

8. Check that the guide rib is not overlaid with the panel.

9. After fitting the U-shaped side of the bezel to the P chassis, attach the bezel by pressing

the two clips close to the lamp into place.

4-84 Satellite M20 Maintenance Manual