User guide

User’s Manual 4-5
Operating Basics
2. Plug the other end of the modular cable into a telephone jack.
Connecting the internal modem
Disconnecting
To disconnect the internal modem cable, follow the steps below.
1. Pinch the lever on the connector in the telephone jack and pull out the
connector.
2. Disconnect the cable from the computer in the same manner.
LAN
The computer is equipped with LAN circuits that support Ethernet LAN
(10 megabits per second, 10BASE-T) and Fast Ethernet LAN
(100 megabits per second, 100BASE-TX), or Gigabit Ethernet LAN
(1000 megabits per second, 1000BASE-T). This section describes how to
connect/disconnect to a LAN.
If you use Gigabit Ethernet LAN (1000 megabits per second,
1000BASE-T), be sure to connect using either a CAT5e or CAT6 cable.
Do not pull on the cable or move the computer while the cable is
connected.
If you use a storage device such as a DVD-ROM drive or Hard Disk Drive
connected to a 16-bit PC card, modem speed might be slow or
communication might be interrupted.
Do not install or remove an optional memory module while Wake-up on
LAN is enabled.
Wake-up on LAN does not work without the AC adapter. Leave it
connected, if you are using this feature.