Operation Manual

SB3950E1 40W Soundbar Speaker System
EN-5
User’s Manual
Introduction
Welcome and thank you for choosing a TOSHIBA product.
We recommend reading this manual carefully and keeping it with your product
documentation for future reference.
Getting Started
Check the illustrations to set up your device properly.
Connecting the power adapter to the SB3950E1
Choose the proper plug to attach to an AC adapter. Plug one end of the AC adapter cable
into the DC In jack of the back of the Soundbar.
DC IN 24V
AC/DC Adaptor
(supplied)
AC Power Cable
(supplied)
(Sample Illustration) Connecting the power
cable to the AC adaptor (2-pin plug)
DC IN 24V
AC/DC Adaptor
(supplied)
AC Power Cable
(supplied)
(Sample Illustration) Connecting the power
cable to the AC adaptor (3-pin plug)
Sound Bar Buttons
5 3 2 14
Surround Volume - Volume + Input
Button
Power
On/Off
Sound Bar Rear
6 8
7
DC-in Jack Optical Line-in
Using the Remote control
While using the remote control, please follow the instruction below. Point the remote control
at the remote sensor and press the buttons at a distance of approximately 5m from the
front of the remote sensor. Angle: 30° in each direction from the front of the remote sensor.
Installing the batteries in the remote control
1. Open the battery cover
2. Insert the batteries
Make sure the polarity marks (+/-) on the batteries match the marks indicated in the
battery compartment
3. Replace the battery cover