Manual

INTRODUCTION I PAGE 11
Preparing the Remote Control )
Insert the batteries into the remote control so you can
use it to operate the DVD player.
Open the battery cover.
_ Insert batteries (AAA size).
• Make sure to match the + and - on the batteries to
the marks inside the battery compartment.
_ Close the cover.
O Improper use of batteries may cause battery leakage and
corrosion.
O To operate the remote control correctly, follow the
instructions.
O Do not insert the batteries into the remote control in the
wrong direction.
O Do not charge, heat, open, or short-circuit the batteries.
Do not throw the batteries into fire.
O Do not leave dead or exhausted batteries in the remote
control.
O Do not use different types of batteries together, or mix
old and new batteries.
O If you do not use the remote control for a long period of
time, remove the batteries to avoid possible damage
from battery corrosion.
O If the remote control does not function correctly or if the
operating range becomes reduced, replace all batteries
with new ones.
O If battery leakage occurs, wipe the battery liquid from the
battery compartment, then insert new batteries.
O The batteries should last about one year with normal
use.
Operating with the Remote Control )
This section shows you how to use the remote control.
Point the remote control at the
remote sensor and press the
buttons.
Within about 23 ft (about 7 m)
@
Distance: About 23 ft (7 m) from the front of the remote
sensor
Angle: About 30° in each direction of the front of the
remote sensor
* Do not expose the remote sensor of the DVD
player to a strong light source such as direct
sunlight or illumination. If you do so, you may not
be able to operate the DVD player with the remote
control.
O Point the remote control at the remote sensor on the
DVD player.
O Do not drop or give the remote control a shock.
O Do not leave the remote control in an extremely hot or
humid place.
O Do not spill water or put anything wet on the remote con-
trol.
O Do not disassemble the remote control.