Manual

PAGE 42 I REFERENCE
Symptoms and Correction )
Check the following guide for the possible cause of a problem before contacting service.
Symptom Cause Correction
No power. • The power cord is disconnected. • Plug the power cord into the wall outlet
securely.
The power is on, but • No disc is inserted. • Insert a disc. (Check that the DVD or,
the DVD player does audio CD indicator in the DVD display is
not work. lit.)
No picture. • The TV is not set to receive DVD signal • Select the appropriate video input mode
output, on the TV so the picture from the DVD
player appears on the TV screen.
• The video cable is not connected • Connect the video cable into the jacks
securely, securely.
• The connected TV power is turned off. • Turn on the TV.
No sound. • The equipment connected with the • Select the correct input mode of the
audio cable is not set to receive DVD audio receiver so you can listen to the
signal output, sound from the DVD player.
• The audio cables are not connected • Connect the audio cable into the jacks
securely, securely.
• The power of the equipment connected • Turn on the equipment connected with
with the audio cable is turned off. the audio cable.
• The Digital Audio Output is set to the • Set the Digital Audio Output to the
wrong position, correct position, then turn on the DVD
player again by pressing the POWER
button.
Theplaybackpictureis poor. • The disc is dirty. • Clean the disc.
The DVD player does • No disc is inserted. • Insert a disc. (Check that the DVD, or
not start playback, audio CD indicator in the DVD display is
lit.)
• An unplayable disc is inserted. • Insert a playable disc. (Check the disc
type, color system and Regional code.)
• The disc is placed upside down. • Place the disc with the playback side
down.
• The disc is not placed within the guide. • Place the disc on the disc tray correctly
inside the guide.
• The disc is dirty. • Clean the disc.
• A menu is on the TV screen. • Press the SETUP button to turn off the
menu screen.
• The Rating level is set. • Cancel the Rating function or change
the rating level.
The remote control • The remote control is not pointed at the • Point the remote control at the remote
does not work properly, remote sensor of the DVD player, sensor of the DVD player.
• The remote control is too far from the • Operate the remote control within about
DVD player. 23 ft (7 m).
• There is an obstacle in the path of the • Remove the obstacle.
remote control and the DVD player.
• The batteries in the remote control are • Replace the batteries with new ones.
exhausted.