Operation Manual

17
3
Automatic TV station presetting
2
1
4
Your DVD/VCR has one built-in tuner
to receive the broadcast. Before you
record one TV-Broadcast, you must
set and preset the whole of the broad-
casts. This DVD/VCR can preset up
to 80 broadcast.
Automatic station presetting
All stations will preset in sequence available in your area.
Preparation:
•Turn ON the TV and set to the video input mode.
• Press VCR to select the VCR mode. (The VCR indicator will light.)
Press VCR MENU.
Press
or to select
CHANNEL SETUP. Then
press ENTER.
Press
or to select AUTO
TUNING.
Press ENTER.
The DVD/VCR will begin searching and setting with early stored
channel, the number is increased by one into memory all the broad-
casting channels available in your area (VHF-L, VHF-H, UHF). While
setting channels, AUTO TUNING appears. When the setting
finished, the CHANNEL MAPPING menu will appear.
Press VCR MENU repeatedly until the TV picture appears on
the screen.
Note: To cancel skipping, select the skipped channel using number
buttons (0-9), then press CANCEL. The channel No. does not blink
any longer, and the channel No. now can be selected again using CH
+/–.
To skip a channel position
Unwanted channels can be skipped so that they cannot be called up
by pressing CH +/–. Select the 29, then press CANCEL. This channel’s
number will be flashing. That way you can cancel further channel
one after the other.
Notes:
• TV reception interference or power fail-
ure may result in Automatic station pre-
setting malfunctions. In such a case
repeat the setting procedure from the
beginning.
However, you cannot receive the nec-
essary broadcast yet, try to preset the
broadcast manually. (See page 21.)
• When the unit is in the auxiliary input
mode, you cannot preset channels.
2J50301A [EN] P17-22 3/22/06, 10:28 PM17