Manual

Initial Settings
You can set your own Personal Preferences on the player.
Initial Settings General Operation
Press SETUP.
The setup menu appears.
Picture
TV Aspect
4:3 Letterbox: Select when a standard 4:3 TV iscon-
nected. Displays theatrical images with masking bars
above and below the picture.
4:3 Panscan: Select when a standard 4:3 TV is con-
nected. Displays pictures cropped to fill your TV screen.
Both side of the original picture may be cut off.
16:9 Wide: Select when a 16:9 wide TV is connected.
Press _ to select the desired item.
The screen will show the current setting for the
selected item, as well as alternate setting(s).
_While the desired item is selected, press I_, then
to select the desired setting.
Press ENTER to confirm your selection.
Some items require additional steps.
Press SETUP, RETURN or PLAY to exit the
setup menu.
Language
Disc Language
Select a language for the disc's Menu, Audio and
Subtitle.
Original : The original language set for the disc is selected.
Other :To select another language, press number buttons to
enter the corresponding 4-digit number according to the lan-
guage code list on page 23. If you enter the wrong language
code, press CLEAR.
Progressive Scan ql_
Progressive Scan Video provides the highest quality
pictures with less flicker and line structure.
If you are using the COMPONENT VIDEO OUT/
PROGRESSIVE SCAN jacks, but are connecting the
DVD Player to a standard (analog) television, set
Progressive Scan to Off.
If you are using the Component Video jacks for
connection to a TV or monitor that is compatible with a
progressive scan signal, set Progressive Scan to On.
Menu Language
Select a language for the setup menu. This is the menu
you see when you press SETUP.
[]Notes
- Progressive Scan only works when the VIDEO OUT-
PUT switch on the rear panel is set to COMPO-
NENT/PROGRESSIVE SCAN.
,/_Caution
Once the setting for progressive scan output is entered, an
image will only be visible on a progressive scan compatible
TV or monitor. If you set Progressive Scan to On in error,
you must reset the unit. Pointing the remote at the player,
press the STOP key to stop any disc that is playing. Next,
press the STOP key again and hold it for five seconds
before releasing it. The video output will be restored to the
standard setting, and a picture will once again be visible on
a conventional analog TV or monitor.