Operation Manual
21
CH TUNING
AUTO TUNING
CHANNEL SETUP
CHANNEL MAPPING
SELECT :
ENTER
: ENTER
MENU
EXIT
:
Manual TV station presetting
1
2
5
4
The Auto CH Memory function (See
page 17) memorizes all broadcasts to
the suitable CH positions.
However, one broadcasts may not be
memorized due to weak signal. In this
case, use manual tuning function.
Note:
Occasionally, the auto search might catch
a weak signal and stop. If the TV station
signal is weak, you shouldn't store this
station.
In that case, restart the auto search us-
ing
or .
Manual station presetting
You can activate the auto search function until your preferred station
is tuned in. Then you memorize this station into the chosen channel
memory. Repeat this procedure for each station.
Preparation:
•Turn ON the TV and set to the video input mode.
• Press VCR to select the VCR mode. (The VCR indicator will light.)
Example: Preset the SAT1 on program position 5.
Press VCR MENU.
Press or to select CHANNEL
SETUP. Then press ENTER.
Press or to select CH TUN-
ING. Then press ENTER.
DEC OFF will blink. Press ENTER.
DEC OFF does not blink anymore.
SEARCH will appear.
Note:
If you wish to store the PREMIERE
manually, the decoder must connect
to this DVD/VCR (see “Connection
to a Decorder (for Premiere Programs)” on page 13).
When DEC OFF is blinking, press .
DEC ON will blink.
Press ENTER.
Press (rising frequency) or
(falling frequency) once. The search
starts. It stops at each broadcast au-
tomatically (“ ” change to “ 4 ”).
Press
or repeatedly until the
SAT1 appears. Only receiving of the
weak broadcast (drifting picture),
search does not stop.
If you want to stop, press
/ or / .
3
B/G will blink. Press or to
select [ B/G ], [ D/K ] or [ I ]. Then
press ENTER.
... to be continued to next page
2K20301A [EN] P17-22 2/3/07, 2:21 PM21