Manual

[] When shipping the DVD video player, the original shipping carton and
packing materials come in handy. For maximum protection, repack the
unit as it was originally packed at the factory. Take care not to give it
a shock or shake when carrying.
[] Do not use volatile liquids, such as insect spray, near the DVD video
player. Do not leave rubber or plastic products in contact with the DVD
video player for a long time. They will leave marks on the finish.
[] The top and rear panels of the DVD video player may become warm
after a long period of use. This is not a malfunction.
[] When the DVD video player is not in use, be sure to remove the disc
and turn off the power.
[] If you do not use the DVD video player for a long period, the unit may
not function properly in the future. Turn on and use the DVD video
player occasionally.
[] Place the DVD video player on a level surface. Do not use it on a shaky
or unstable surface such as a wobbling table or inclined stand. The
loaded disc may come off the proper position and cause damage to the
DVD video player.
[] When you place this DVD video player near a TV, radio, or VCR, the
playback picture may become poor and the sound may be distorted.
In this case, place the DVD video player away from the TV, radio, or
VCR.
Use a soft, dry cloth for cleaning.
• For stubborn dirt, soak the cloth in a weak detergent solution, wring
well and wipe. Use a dry cloth to wipe it dry.
Do not use any type of solvent, such as thinner and benzine, as they
damage the surface of the DVD may video player.
• If you use a chemical saturated cloth to clean the unit, follow that
product's instructions.
This DVD video player is a high technology, precision device. If the optical
pick-up lens and disc drive parts become dirty or worn down, the picture
quality may be reduced. To avoid reduction in picture quality, it is
recommended that regular inspection and maintenance (cleaning or parts
replacement) be performed every 1,000 hours of use. For further details,
contact your nearest consumer electronics dealer.
Moisture condensation damages the DVD video player. Please read the
following carefully. 5
Moisture condensation occurs, for example, when you pour a cold drink o
c
into a glass on a warm day. Drops of water form on the outside of the o
glass. In the same way, moisture may condense on the optical pick-up =5
lens inside this unit, one of the most crucial internal parts of the DVD
video player.
[] Moisture condensation occurs during the following cases.
• When you bring the DVD video player directly from a cold place to a
warm place.
• When you use the DVD video player in a room where you just turned
on the heater, or a place where the cold wind from the air conditioner
directly hits the unit.
• In summer, when you use the DVD video player in a hot and humid
place just after you move the unit from an air conditioned room.
• When you use the DVD video player in a humid place.
[] Do not use the DVD video player when moisture condensation may
occur.
If you use the DVD video player in such a situation, it may damage
discs and internal parts. Remove the disc, connect the power cord of
the DVD video player to the wall outlet, turn on the DVD video player,
and leave it for two or three hours. After two or three hours, the DVD
video player will have warmed up and evaporated any moisture. Keep
the DVD video player connected to the wall outlet and moisture
condensation will seldom occur.
on Dbcs
• Do not touch the playback side of the disc.
O
Playback side
• Do not attach paper or tape to discs.
• Fingerprints and dust on the disc cause picture and sound deterioration.
Wipe the disc from the center outwards with a soft cloth. Always keep
the disc clean.
O
O If you cannot wipe off the dust with a soft cloth, wipe the disc lightly
with a slightly moistened soft cloth and finish with a dry cloth.
• Do not use any type of solvent such as thinner, benzine, commercially
available cleaners or antistatic spray for vinyl LPs. It may damage the
disc.
5
p2*17*3990SU,pmd 5 30/9/2005, 10:31 AM