TOSHIBA Storage Device Division CD-RW/DVD-ROM DRIVE SD-R1202 Installation Instructions with VOB InstantCD/DVD and CyberLink PowerDVD Software TM VERSION 2.
CD-RW/DVD-ROM DRIVE Instruction Instructions For the following Drive: SD-R1202 TOSHIBA AMERICA INFORMATION SYSTEMS, INC. STORAGE DEVICE DIVISION 9740 Irvine Blvd. Irvine, CA 92618 Contents of this manual are subject to change without prior notice. © 2002 TOSHIBA AMERICA INFORMATION SYSTEMS, INC.
Limited Warranty Toshiba America Information Systems, Inc. Storage Device Division 9740 Irvine Boulevard, Irvine, California 92618 1-949-583-3000 What does my limited warranty cover? Toshiba America Information Systems, Inc. (“Toshiba”) warrants the Toshiba Storage Product (“Product”) you have purchased from Toshiba or from a Toshiba authorized dealer is free from defects in materials or workmanship under normal use during the warranty period.
Disclaimer and limitation of remedy ALL OTHER EXPRESS AND IMPLIED WARRANTIES FOR THIS PRODUCT, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE AND/OR NONINFRINGEMENT OF THIRD PARTY RIGHTS, ARE HEREBY DISCLAIMED. TOSHIBA EXPRESSLY DISCLAIMS ALL WARRANTIES NOT STATED IN THIS LIMITED WARRANTY. ANY IMPLIED WARRANTIES THAT MAY BE IMPOSED BY LAW ARE LIMITED IN DURATION TO THE TERM OF THIS EXPRESS LIMITED WARRANTY.
Table of Contents Checking your Kit Packaging ...................................................................... 1 System Requirements .................................................................................... 1 Setting Jumpers ............................................................................................. 2 Placing CD-RW/DVD-ROM inside your computer ...................................... 2 Connecting Cables ........................................................................
Congratulations on your purchase of a Toshiba CD-RW/DVD-ROM drive and Kit. The following information will help you in the simple installation of your new CD-RW/DVD-ROM drive.
The following steps must be performed to properly install your CD-RW/DVDROM. ! Set drive’s jumpers ! Connect audio cable ! Attach IDE BUS cable ! Connect power cable ! Mount CD-RW/DVD-ROM ! Install CyberLink PowerDVD™ software (used for viewing DVD movies) ! Install VOB InstantCD/DVD software (used for recording CDs) SETTING JUMPERS The mode select jumpers are six (6) straight pins located on the rear of the CD-RW/ DVD-ROM.
1. Remove computer cover and faceplate if required (refer to your computer system’s manual for removal information). 2. If the CD-RW/DVD-ROM is replacing a CD-ROM, disconnect all connectors and remove the CD-ROM presently installed in your system. 3. Your Toshiba CD-RW/DVD-ROM can be placed in any free half-height drive slot at the front of your computer. (It can be mounted horizontally or vertically.) 4.
Connect secondary IDE BUS cable to CD-RW/DVD-ROM drive, assuring that pin 1 of the cable (side with red stripe) is connected to pin 1 on the drive. • If the CD-RW/DVD-ROM is the only drive connected on the secondary IDE BUS cable: connect drive to the last set of pins on IDE BUS cable. • If there is a device (i.e. CD-ROM) connected to the secondary IDE BUS cable: connect CD-RW/DVD-ROM to the open middle connector . The CDRW/DVD-ROM drive should then be jumpered to SL (slave) position.
COMPLETING INSTALLATION After you have connected all the necessary cables, push the CD-RW/DVD-ROM completely into the computer’s drive slot. Mount the drive per your computer’s instructions using the screws included in your kit. If you are using other screws, assure that the screw length does not exceed 3±0.5mm (measured from outside surface of side or bottom of CD-RW/DVD-ROM to tip of screw). Replace the computer cover and all outer screws.
CyberLink PowerDVD: *Before installing CyberLink software it is recommended you visit CyberLink’s website to check for any software updates (http://www.gocyberlink.com). CyberLink PowerDVD™ is a high-quality, pure-software DVD player that brings high-quality movies and karaoke into your multimedia PC. You can playback high resolution DVD titles or MPEG-2 files with superb MPEG-2 video and Dolby AC-3 audio quality. To install, insert CyberLink PowerDVD™ into your newly installed CD-RW/DVDROM.
1. 2. 3. Turn CD-RW/DVD-ROM drive power OFF. Insert a solid bar (i.e. large paper clip*) into Emergency Eject hole and push in as shown in the picture below. CD-RW/DVD-ROM tray will open/eject. This procedure cannot be repeated without cycling the drive’s power. After the media is removed and the loading tray is closed, the tray will not reopen without first turning the power ON/OFF. * Use a bar that is less than 1.5mm in diameter. Do not insert more than 50mm in depth as this may damage the drive.
SPECIFICATIONS DVD CD DATA CAPACITY 2,048 Byte/Block 2,048 Byte/Block (mode 1) 2,336 Byte/Block (mode 2) CD-ROM, CD-R: 8,561rpm (13.8 - 40X) CD-RW: 3,281rpm (8.6 - 20X) CD-DA Transfer: 3,200rpm (12.7 - 16X) CD-DA, Video-CD: 1,200 - 2,000rpm (4 - 6X) 2,550-5,940rpm (12X CLV) 850-1,980 rpm (4X CLV) 2,125 - 4,950 (10X CLV) ROTATIONAL SPEED DVD : 7,580rpm (12X - Single Layer) 5,053rpm (3.3-8X -Dual Layer) DVD-R (Ver 2), DVD-RW, DVD-Video : 2,780rpm (2-4.8X) DVD-R (Ver 1): 3,200rpm (2 - 4.
8
460023-B0 P/N 460023-B0
