Manual

I I
Symptom Cause Solution
INPUT, VOLUME (_hJ_') • Incorrect mode (e.g. Remote control in • Press DVD/CD, VCR or FM/AM to
and 4/_.,/Am' buttons on TV mode), select the correct mode on the remote
remote control cannot control.
operate.
Some channels are • Those channels were deleted with the • Use CH. ADD/DEL to restore channels.
skipped over when using CH. ADD/DEL option. See "Channel Selection" on page 18.
CH/TRK (A/T)
Picture and sound of • Antenna or cables are loose. • Tighten connections or replace cable.
broadcasting channel are
weak or missing. • Wrong CHANNEL SOURCE option is • Try all CHANNEL SOURCE options.
being used. See "Channel Selection" on page 18 for
details.
Camcorder image is not • Camcorder is off. • Turn camcorder on and operate
shown, properly.
Camcorder image via • DVDNCR Receiver INPUT SELECT is • Press INPUT to select LINE input chan-
AN input to DVDNCR not set to LINEI(L1) or LINE2(L2). nel (LINEI(L1) or LINE2(L2)).
Receiver is not shown on
TV screen.
Timer recording is not • Clock in DVDNCR Receiver is not set • Set clock to correct time. See "Setting
possible, to correct time. the Clock" on page 19.
• Timer has been programmed • Reprogram Timer. See "Timer
incorrectly. Recording" on pages 25 and 26.
• Q indicator light does not appear after • Reprogram Timer.
programming timer.
Stereo Audio Record • TV is not Stereo-compatible. • No action is possible.
and/or Playback is not • Broadcast program is not in stereo for- • No action is possible.
present, mat.
• DVDNCR Receiver AN Out jacks are • Make AN connections. Stereo is
not connected to TV AN In jacks, available only via A/V output from
DVD/VCR Receiver.
• DVDNCR Receiver AudioNideo Out is • Select AUX or A/V source as TV input.
not selected for viewing at the TV.
• DVDNCR Receiver BROADCAST • Set BROADCAST TYPE mode to
TYPE mode is set to SAP or MONO. STEREO. See "VCR Setup Menu
Option" on page 18.
Severe hum or noise is • The plugs and jacks are dirty. • Wipe them with a cloth slightly mois-
heard, tened with alcohol.
Radio stations cannot be
tuned in.
• The disc is dirty.
• The speakers and components are
connected poorly.
• The DVDNCR Receiver is located too
close to the TV.
• The antenna is positioned or connected
poorly.
• Clean the disc.
• Connect the speakers and components
securely.
• Move your TV away from the audio
components.
• Connect the antenna securely.
• Adjust the antennas and connect an
external antenna if necessary.
• The signal strength of the stations is too • Tune in the station manually.
weak (when tuning in with automatic
tuning).
• No stations have been preset or preset • Preset the stations (page 38).
stations have been cleared (when
tuning by scanning preset stations).
No sound from DIGITAL • DVDNCR Receiver source is not set to • Select OPTICAL by pressing AUX once.
AUDIO IN (OPTICAL). DIGITAL AUDIO IN (OPTICAL).
I I