Stratagy Installation Guide

Installation
Step 7: Install Stratagy Admin Software (VSA.3x)
Stratagy IVP8 Installation Guide 01/02 15
Step 7: Install Stratagy Admin Software (VSA.3x)
Important! Stratagy Admin Release 3 software is only supported by the Stratagy IVP8,
Stratagy Flash and the Stratagy DK Release 3 and cannot be used with other
Release 2 systems.
Note Loading the Stratagy Admin software can be done before/after connecting the Stratagy
Admin PC to the Stratagy IVP8.
The Stratagy Admin PC, connected to the Stratagy IVP8 (see Step 8 on page 16), must meet the
following specifications:
• IBM-compatible
• 3.5” 1.44 (high-density) floppy-disk drive
• Hard drive with a minimum of 5MB of available disk space
• 580KB RAM free memory
CAUTION! Do not install the Stratagy Admin VSA.3x software into an existing Admin2 or
Admin3 directory used for Release 2 systems. If you do, file corruption can
occur when communicating with a Stratagy IVP8.
➤ To install Stratagy Admin Software
1. Insert the Stratagy Admin disk into the floppy disk drive of the Stratagy Admin PC.
2. Access the DOS prompt (
C:\).
3. To begin the installation procedure, type
a:install c:\admin3x
where: x = the version letter of the Admin software you are installing.
Note It is recommended that you not overwrite the current Stratagy Admin directory but create a
new directory.
4. Press any key to continue. The Stratagy Admin program is installed on drive C: in subdirectory
ADMIN3x.