Stratagy Installation Guide

4
,V6WUDWD'.·V'70)WRQHGHWHFWLRQHQDEOHG"
Strata DK needs to recognize Stratagy’s DTMF signaling.
❐ Make sure an RRCS is installed on the DK424i/DK424/DK280 RCTU, a K5RCU, K5RCU2 or K4RCU3 in
the DK40i/DK40/DK16e/DK16, or CRCU in the DK24/DK56/DK96.
❐ Run Program 03 and assign these code(s) where the DTMF receiver is installed:
5
'R\RXZDQWWRDFWLYDWHWKH'66%XV\/DPSIHDWXUH"
A PDKU card must be installed that is programmed for a DSS Console.
❐ Install and program the PDKU:
DK424i/DK424/DK280
: When installing the Stratagy in an odd-numbered cabinet, make sure the PDKU is
in a lower-numbered slot in the same cabinet. When installing in an even-numbered cabinet, the PDKU must
be in a lower-numbered slot in the preceding odd-numbered cabinet.
DK40i/DK40/DK16e
: set slot 11 in the Base Cabinet to code 64.
DK24/DK56/DK96
: the PDKU must reside in slot 01.
❐ Set code 64 using Program 03 for the PDKU slot.
❐ Set the dss_active parameter to TRUE.
❐ Configure the DSS Port field on the User Menu – Options screen for each mailbox.
6
$UH\RXJRLQJWRKDYH60',"
A PIOU/PIOUS, RSSU, or RSIU/RSIS card must be located close to the Stratagy.
❐ Strata DK424i/DK424/DK280: SMDI is available on all processors. The A processor must have Release 3.1
software or higher.
❐ Set code 43 in Program 03 for PIOU/PIOUS/RSSU or code 49 for RSIU/RSIS.
❐ A serial cable must be installed between the PIOU/PIOUS/RSSU/RSIU card and the Stratagy. Toshiba’s
PPTC-9 (with six-conductor line cord) is recommended.
❐ Stratagy’s serial Port 1 is reserved for SMDI communication.
7
:DQWWRV\QFK6WUDWDJ\V\VWHPWLPHZLWK6WUDWD'."
You’ll need an LCD telephone physically installed on the first port of the Strata DK’s PDKU card (see Step 5)
card. It is important that the phone’s LCD always displays the system time. For this to happen, no other LCD
features, including MW Indication, can be enabled on this phone.
❐ You must configure the ksu_time and console_slot_id parameters.
❐ The Strata DK uses a 24-hour system clock, but does not notate a.m./p.m. on the LCD display. Because of this,
during the initial installation or when the system has been shut down for any extended time, it is necessary to
program the correct date and time in the Stratagy Main Menu, Date/Time function or via Admin mailbox.
8
$OOVHW"-XVWDIHZPRUHWKLQJV
❐ Be sure to change the default password of the Shutdown Mailbox User ID 983 (see page 40 in the
Stratagy IVP8 or Stratagy DK Installation Guide).
❐ Don’t forget to wear the anti-static wrist strap during handling.
❐ When using an internal modem in the Stratagy Admin PC, remember that Stratagy Admin does not work with
COM 3 or 4. Do not write over the Stratagy Admin subdirectory on your remote PC when installing the newer
version of Stratagy Admin. Always retain previous versions of Admin.
❐ Make sure your Strata I&M/Programming Manuals and Stratagy I&M Manuals are handy. Be sure to read
the entire Stratagy IVP8 or Stratagy DK Installation Guide before installing.
❐ Remember to back up your database after installation.
If you have read and completed this checklist, installation will be a breeze!
OK, let’s get started!
DK424i/DK424/280 DK40i/DK40/DK16e/DK16 DK24/DK56/DK96
Code 92, 93, or 94 for slot 00 Code 92 for slot 00 Code 92 or 93
4011043