HD-XE1 HD-EP10 Ethernet Connection Quick Setup Guide HD-E1
Ethernet Connection with Router Toshiba Server The network connection feature may be used to update the player’s firmware. After making the proper connection to the network, please ensure that your player has the latest firmware update (see page 6). Toshiba HD DVD Player Router Internet ISP Internet Service Provider Head-end “Always On” Broadband Modem The use of a router may be restricted or not allowed, depending on ISP policies.
Ethernet LAN Connection Rear panel layout varies according to model. Use a commercially available straight LAN cable (Category 5/CAT 5 or better with RJ45 connector). Connecting Using a Router (e.g. ADSL) Router Broadband Modem Broadband Service Depending on the ISP, the number of devices that can receive internet service may be limited by the terms of service. Contact your ISP for details.
Setup DHCP Setting 1. Connect RJ45 Ethernet cable to the Ethernet port on the back of the player. 3. From the SETUP menu, select “Ethernet” 2. With the HD DVD player ON, press the SETUP button on the remote. 4. From the “Ethernet” sub-menu, select DHCP DHCP (Dynamic Host Configuration Protocol) is a set of rules (protocol) used by communication devices such as computers, routers, or network adapters to allow the device to request and obtain IP addresses from servers containing available addresses.
Setup 5. Set DHCP and DNS to “On”. (DNS Servers [Domain Name Servers] translate domain names to IP addresses.) 6. Confirm the DHCP and DNS changes. 7. If SETUP is successful, select OK.
Setup 9. Press SETUP button to save settings. 10. Press the Power button to turn off — wait until the Power button light color changes to red. 11. Press the Power button again to turn it on. You may use the Web-enabled internet connection feature to update the player’s firmware. To do so, please follow #12-14. 8. Set NTP Server to “On” 12. From the SETUP menu, select “General” 13. Select “Maintenance” 14. Select “Update” and then select “Yes” and then press the OK button on the remote.
HD DVD Assistance for Web-Enabled Network Content Detailed Troubleshooting If, while attempting to access the web-enabled network content of a HD DVD disc, you encounter an error status code, please note the specific code that is shown on the screen. 10 No Connection Could Be Made To Server The HD DVD player detected that it cannot connect to the server.
Important Notes About HD DVD HD DVD with high-definition content required for HD viewing. Viewing high-definition content and up-converting DVD content may re quire an HDCP capable DVI or HDMI input on your display device. Firmware update may be required for some interactive features depending on content, which may also require an always-on broadband internet connection. Some features may require additional bandwidth. MP3/WMA audio files not supported. HDMI audio support for PCM only.
