Operation Manual

Preparation for use

Connection procedure

Connecting a video device (component video/HDMI device)

This monitor can be connected to a video device equipped with component output such as a DVD player.

Refer to the user’s manual of the connected device for details. (Cables shown in the gure below are commercially

available.)

• To connect a DVD player equipped with component output to the D-SUB/YPbPr IN connector on the monitor, use a signal cable

(mini D-SUB 15-pin – BNC) and a BNC – RCA adaptor (commercially available).

Select [YPbPr] using the INPUT button on the monitor or the YPbPr button on the wireless remote control. At the moment of the

selection, the audio is automatically switched to [ANALOG].

• To make audio connection, connect an audio cable (ø3.5-mm stereo mini – RCA) to the AUDIO ANALOG IN connector.

Because the audio is automatically switched to [ANALOG] when [YPbPr] is selected, the audio is output just by connecting the

cable.

• To connect a DVD player equipped with HDMI output to the HDMI1 IN or HDMI2 IN connector on the monitor, use an HDMI

cable.

Select [HDMI1] or [HDMI2] according to the connected connector by pressing the INPUT button on the monitor or the HDMI1

or HDMI2 button on the wireless remote control.

• When connecting an HDMI cable, you can select HDMI1, HDMI2, or ANALOG audio. (You can select HDMI audio only when

the video input is [HDMI1] or [HDMI2].)

HDMI cable

HDMI1 IN or

HDMI2 IN

To video output

To HDMI output

To audio output

Signal cable (mini D-SUB 15-pin – BNC)

Audio cable

(ø3.5-mm stereo mini – RCA)

BNC – RCA adaptor

AUDIO

ANALOG IN

D-SUB/YPbPr IN

DVD player

(component device)

LCD display (rear)

DVD player

(HDMI device)

LCD display

(side)

(Sample Illustration) 42”

Connecting a video device (component video/HDMI device)