Operation Manual

27
Preparation for use
Connection procedure
Connecting a video device (composite video/ S video device)/stereo amplifier
This monitor can be connected to a composite video or S video device or a stereo amplier. Refer to the user’s manual of
the composite video or S video device or the stereo amplier for details. (Cables shown in the gure below are
commercially available.)
• To connect a video device to the VIDEO IN connector (VIDEO IN or S-VIDEO IN) on the monitor, use a BNC cable or an S
video cable. For connection to the audio input connector on the monitor, use an audio cable (ø3.5-mm stereo mini – RCA).
Connect the connectors of the audio cable (RCA) correctly. For connection to the VIDEO IN connector, select [VIDEO] using the
INPUT button on the monitor or the VIDEO button on the wireless remote control. For connection to the S-VIDEO IN connector,
select [S-VIDEO] using the INPUT button on the monitor or the S-VIDEO button on the wireless remote control.
• To connect two monitors, connect one end of a BNC cable to the VIDEO OUT connector of the rst monitor and the other end to
the VIDEO IN connector of the second monitor.
• In the daisy chain connection, you can connect up to 5 monitors (when using 5-meter cables). However, the maximum
number of connectable monitors may be limited depending on the connected devices to be used. It is recommended to
check the number of connectable monitors in advance in your installation environment.
• When an analog signal is transmitted through the daisy chain, the picture quality such as brightness and sharpness
degrades at the latter devices in the daisy chain connection.
• When different monitors need to be adjusted so that their tint can be identical, such as when using multiple screens, it is
recommended to use a signal distributor (commercially available).
• When connecting a stereo amplifier to the monitor, be sure to turn off the power of the stereo amplifier. For connection to
the AUDIO ANALOG OUT connector on the monitor, use an audio cable (ø3.5-mm stereo mini – RCA). Connect the
connectors of the audio cable (RCA) correctly. Be sure to turn on the monitor first, and then turn on the stereo amplifier.
• The selected audio input signal is output from the AUDIO ANALOG OUT connector.
BNC cable
S-VIDEO IN
AUDIO
ANALOG IN
AUDIO
ANALOG OUT
VIDEO IN
VIDEO IN
VIDEO OUT
To S video output
To video output
To audio output
To audio input
Audio cable
(ø3.5-mm stereo mini – RCA)
Audio cable (ø3.5-mm stereo mini – RCA)
BNC cable
S video cable
LCD display (second display)
LCD display (first display)
Stereo amplifi er
External speakers
Video device
(composite video/S video device)
(Sample Illustration) 42”
Connecting a video device (composite video/ S video device)/stereo amplier