Operation Manual

29
Preparation for use
Installing the expansion module
Mounting the OPS-compliant computer on the monitor
1 Turn off the main power switch of the monitor and disconnect the power cord.
Be sure to disconnect the power cord to prevent breakdown and electric shock.
2 Unscrew 6 screws (a) and remove the option cover.
(a)
(a)
Option cover
Retain the option cover you have removed because it is replaced when the OPS-compliant computer isn’t mounted.
3 Install the option slot cover (accessory) using the 4 screws (a)
that you have removed in step 2.
Insert an OPS-compliant computer (commercially available)
in the option slot and secure it on the monitor using the 2
screws (a) that you have removed in step 2.
(a)
(a)
(a)
Option slot cover
(accessory)
OPS-compliant
computer
(commercially
available)
Option slot
After installing the option slot cover, ensure that the OPS-compliant computer is positioned and oriented properly and
then insert it fully into the slot. The device may be damaged if installed in an incorrect position and orientation.
Removal of the OPS-compliant computer
Hold the handle on the OPS-compliant computer for removal.
Extract the OPS-compliant computer by using the handle only. Pulling on the cable or other means may cause damage.
Mounting the OPS-compliant computer on the monitor