Operation Manual

Preparation for use

Connecting the power cord to the monitor

Connecting the power source

Before making connections

• Check that the main power switch is off.

When an OPS-compliant computer is installed and the main power switch of the monitor is on, connecting the power

source may cause the computer to power on, causing damage or breakdown of the operation system and the hard disc.

• The power outlet socket should be installed as near the equipment as possible and should be easily accessible.

Please refer to “Important Safety Instructions” and “Installation, Ergonomics, Care, and Service” in this manual for

proper selection of the AC power cord. Use the clamper to prevent accidental disconnection of the power cord.

1 Insert the power connector of the power cord fully and rmly into the AC IN connector of the monitor.

2 Secure the power connector using the cable holder (accessory).

Don’t insert the cable holder into the power outlet socket. Doing so may cause electric shock.

1) Fit both ends of the cable holder to the monitor.

2) Rotate the cable holder and hook it to the power

cord.

3) Secure the power connector with the cable holder.

Main power switch

Cable holder (accessory)

Power connector

3 Secure the power cord using the clamper (accessory).

4 Insert the power plug into the power outlet socket.

• Fully insert the prongs into the power outlet socket. Loose

connection may cause noise.

• Don’t plug and unplug the power cord repeatedly in a short

time of period.

Power cord (For EU)

Power cord (For North America)

Clamper (accessory)

Connecting the power cord to the monitor