Operation Manual
58
How to Use
Configuration 2
Mode Description
SERIAL CONTROL
Select the communication interface (RS-232C, OPS (OPS-compliant computer), or LAN) for
the serial communication function.
For connection of the signal cable, see page 30.
LAN SETTING
You can set the communication parameters for the LAN network.
DHCP CLIENT:
Select whether to use DHCP client or not. Select OFF when not using it, and
select ON when using it.
IP ADDRESS:
When DHCP CLIENT is OFF, set the IP address of the monitor. When
DHCP CLIENT is ON, you can check the value set by the DHCP server.
SUBNET
MASK:
When DHCP CLIENT is OFF, set the gateway mask. Set it to
255.255.255.0 for normal use. When DHCP CLIENT is ON, you can check
the value set by the DHCP server.
DEFAULT
GATEWAY:
When DHCP CLIENT is OFF, set the IP address of the gateway router to
externally connect the local area including the monitor.
When DHCP CLIENT is ON, you can check the value set by the DHCP
server.
PORT: The port number (60822) of the monitor is displayed.
RESET: LAN settings are reset.
CONTROL TIME OUT
When using remote control, the timeout for transmission intervals among codes within the
control command can be set.
10 ms: Set the time out intervals to 10 milliseconds.
2 s: Set the time out intervals to 2 seconds.
30 s: Set the time out intervals to 30 seconds.
MONITOR ID
ID numbers for wireless remote control are assigned to TD-Z421 and TD-Z471 monitors that
are multi-connected via RS-232C. ID numbers 1 to 26 are selectable.
OSD TURN OFF
The OSD control menu will stay on as long as it is used.The preset choices are 5 -120
seconds.
OSD H POSITION You can adjust the horizontal position of the OSD menu.
OSD V POSITION You can adjust the vertical position of the OSD menu.
OSD ROTATION The OSD screen is rotated.
Conguration 2