Operation Manual
59
How to Use
Mode Description
INFORMATION OSD
You can enable and disable the information OSD display. The display time is selectable from
3 to 10 seconds.
The information OSD display shows a message when the input source is switched,
the input signal state is changed, or the input signal has an error.
OFF TIMER
You can select the OFF TIMER mode. Select the time period to automatically turn off the
power from 1 to 24 hours.
When OFF TIMER is enabled, the SCHEDULE settings (see page 41) will be disabled.
SCHEDULE
You can program the LCD display operation schedules. (See page 42)
< HOW TO SETUP SCHEDULE >
Using the “SCHEDULE” function allows you to set up to seven different scheduled time
intervals when the LCD display will be activated.
You can select the time the monitor turns on and turns off, the day of week the monitor is
activated, and which input source the monitor will use for each scheduled activation period.
A check mark in the box next to the number of the schedule indicates that the selected
schedule is in effect.
To select which schedule to set, use the up/down arrows to move the number (1 to 7) of the
schedule.
Use the (+) and (-) buttons to move the cursor horizontally within the particular schedule.
Use the ▲ and ▼ buttons to increase the time and select the input port. The “SET” button is used
to make a selection. If you create a schedule but do not want to set the power on time, select “--” in
the “ON” time slot.
If you do not want to use a power off time select “--” in the “OFF” time slot.
If there is no input selected (“--” showing in the input spot) the input from the previous schedule
will be used.
The selection of EVERY DAY within a schedule takes priority over other schedules that are set up
to operate weekly.
When schedules are overlapping, scheduled Power ON time has priority over scheduled Power
OFF time.If there are two schedules programmed for the same time, then the highest numbered
schedule has priority.
When OFF TIMER is enabled, the “SCHEDULE” settings are disabled.
DATE AND TIME
You can adjust the current date and time for the internal clock. You must set this item when
using SCHEDULE. After competing the setting, be sure to press the SET button (button on
page 11). When using a button of the monitor, use the INPUT button (button on page 11).
MONITOR
INFORMATION
The model name and the serial number of your monitor are displayed.The MAC address of
LAN is displayed.
Conguration 2