Operation Manual

61
How to Use
Mode Description
SCAN MODE
(This function doesn’t work when the D-SUB video input is selected.)
You can select the image display area.
OVERSCAN: About 95% of the input image is displayed.
UNDERSCAN: Almost 100% of the input image is displayed.
SCAN CONVERSION
(This function doesn’t work when the D-SUB video input is selected.)
It works on interlace signals only. You can select the IP conversion mode.
PROGRESSIVE:
Interlace signals are converted into progressive signals. Select this
setting for normal cases.
INTERLACE:
Interlace signals are displayed without being converted. Though this
setting is suitable for motion images, still images aren’t displayed properly.
FILM MODE
(This function doesn’t work when the D-SUB video input is selected.)
It works on interlace signals only. You can select the lm mode function.
AUTO:
Images of 24 frames per second are detected, subjected to interpolation,
and then displayed.
OFF:
The input video signals are displayed without being subjected to any
processing.
When FILM MODE is AUTO, set SCAN CONVERSION to PROGRESSIVE.
ClearScan™
You can enable the double-speed clear picture function (ClearScan
™
).
Moving images displayed at 60 frames per second are interpolated into 120-frame-per-
second images for smooth and sharp image quality.
OFF: Not interpolated
MIDDLE: Interpolated (Typical)
HIGH: Interpolated (for smoother and sharper image)
Frame interpolation may cause noise and smear. To reduce noise and smear, select OFF.
IR CONTROL
You can lock the wireless remote control.
Select from the following 4 modes using the  and  buttons and then determine the selected
mode by pressing the SET button.
NORMAL: All the remote control operations are enabled.
PRIMARY:
The rst TD-Z421 and TD-Z471 monitors of those multiconnected via
RS-232C is designated as PRIMARY.
SECONDARY:
TD-Z421 and TD-Z471 monitors other than the rst one multi-connected
via RS-232C are designated as SECONDARY.
LOCK: All the remote control operations are disabled.
When you hold down the DISPLAY button on the wireless remote control for at least 5
seconds, the NORMAL mode is activated. You can lock the wireless remote control
independently from the control buttons on the rear of the monitor. See page 64.
TILING
TILING is a function to divide or enlarge images and display them across multiple screens.
You can divide an input video up to ve pieces horizontally and vertically and display them
on a single large screen comprised of up to 25 (5 x 5) monitors tiled together.
A same video signal needs to be input to each monitor. When different monitors need to
be adjusted so that their tint can be identical, it is recommended to use a signal
distributor (commercially available). When TILING is activated, PIP, POP, SBS, and
STILL are disabled. TILING doesn’t work in the REAL picture size mode.
While TILING is active, you cannot set MOTION of SCREEN SAVER in the
CONFIGURATION1 menu to ON.
Advanced Option