Operation Manual

■

CONTROL terminal

Conditioning of the projection unit

can be also done by a computer via

the RS-232C.

● Pin assignment

● Interface format

1. Communication method RS-232C, 9600bps, No Parity, Data Length: 8 bits;

Stop Bit Length: 1 bit

2. Communication format

Only 1 command valid per communication.

3. Data format For input commands, only ASCII-compliant

all-uppercase alphanumeric characters supported.

4. Replies

If commands are to be sent consecutively, wait for the response from the projector

before sending the next command.

● Main Commands

Item Command Item Command

DVD play DPL Input Component IN2

DVD stop DST Input HDMI IN3

Vol. up VLU Input Video IN9

Vol. down VLD Input S-video INA

Input Computer IN1 Input DVD INB

■ Note

• Contact your dealer for control cable and other commands.

STX (02h) Command (3Byte) ETX (03h)

Acknowledge ACK (06h) CR (0Dh) Data ... Normally ended

ACK (06h) ESC (1Bh) ... Aborted

No acknowledge

NAK (15h)

Speciﬁ cation (Continued)

Pin No. Signal Name Description

1 N.C No connection

2 RXD Receiving data

3 TXD Sending data

4 DTR Data terminal ready

5 GND Signal ground

6 DSR Data set ready

7 RTS Request to send

8 CTS Consent to send

9 N.C No connection

D-sub 9 pin