Operation Manual

20
Preparingandusingtheremotecontrol
Notes
• Whenyouuseforthersttimeafter
purchase, a plastic sheet is provided
between the battery and its contact. Be
sure to remove by pulling it off.
• Whenoperatingtheremotecontrolfrom
behind the projector, the signal beam is
reflected on the projecting surface and
may travel a shorter distance to reach
the projector depending on the shape
and material of the projecting surface.
■Operatingtheremote
control
Point toward the projector’s
infraredremotesensor,andpressa
buttonontheremotecontrol.
• Operatingtheprojectorfromthefront
Approx. 7m
Approx.15
■ Loading a coin cell battery
intotheremotecontrol
j Removethebatteryholder.
Hold down the side release firmly and pull
out the battery holder.
k Load a coin cell battery (CR2025).
Be sure to align the plus and minus ends
of the battery properly.
3
V
O
L
T
S
CR2025
l Replace the battery holder back
intotheremotecontrol.
M
3
V
O
L
T
S
CR2025
Coin cell battery
• Beforeusingthebattery,besuretoobservetheSafetyPrecautionsdescribedinprevious
pages.
• Removethebatteryfromremotecontrolwhennotusingforextendedperiods.
• Iftheremotecontrolstopsworking,orifitsrangedecreases,replacethebatterywitha
new one.
• Keepthebatteryawayfromthereachofchildren.Batteryischokinghazardandcan
be very dangerous if swallowed. If the battery is swallowed, seek medical assistance
immediately.
Theremotecontrol
• Theremotecontrolmayfailtooperateiftheinfraredremotesensorisexposedtobright
sunlight or fluorescent lighting.
• Donotdroporbang.
• Donotleaveinhotorhumidlocations.
• Donotallowittogetwetorplaceitontopofwetobjects.
• Donottakeapart.
• Inrarecases,ambientconditionscouldimpedetheoperationoftheremotecontrol.Ifthis
happens, point the remote control at the main unit again, and repeat the operation.