Instruction Manual

- 34 -
EO1-11126
MA-1350-1 SERIES
(or , )
Returned Merchandise
Depress prior to or any time (before the final
key at the latest) during the entry
sequence of the following operations:
Department Entries
PLU Entries
Percent Discount/Charge on a Department or
PLU Item (NOTE 1)
NOTES: 1. When an item once purchased with a Percent Discount or Percent Charge is returned, the
item can be returned with the Percent Discount/Charge by attaching the [RTN MDSE] key to
the same entry procedure as purchase.
At Purchase At Return
MEAT 7.00 TF
%-
5% 0.35-
RTN
MEAT 7.00-TF
%-
5% 0.35
The process of the amount resulted from % calculation is reversed at Return.
RTN
MDSE
2. The Returned Merchandise entries are possible outside as well as inside a sale. Over-
subtraction of the sale is allowed for Returned Merchandise entries.
3. Neither Negative Department nor Negative PLU items can be entered as Returned Merchan-
dise.
4. Returned Merchandise transaction can be programmed to require the MGR position of the
Control Lock. If so programmed, an error will occur on depressing the [RTN MDSE] key in
the REG position. In this case, ask the store manager to turn the Control Lock to the MGR
position for the transaction. (Refer to the chapter 1. Operations in “MGR” Mode on page 1
in Manager’s Guide.)
Non-add Number Print
Dept. 1 (MEAT) $7.00 is
entered but returned.
RTN
MEAT 7.00-TF
. . .
#/NS
Code Number;
Max. 8 digits
NOTES: 1. The preceding zeros, if any, will not be printed. For example, if “0123000” is entered,
“123000” is printed.
2. Usually, Non-add Number entries are prohibited at the starting of a No-sale transaction (i.e.
Non-add Numbers cannot be printed on a No-sale receipt). However, a No-sale entry can be
programmed to be allowable after a Non-add Number entry (ask your TOSHIBA TEC
representative).
3. Usually, Non-add Number entry is allowed multiple times in one sale. However, it can be
programmed to be allowed only once (ask your TOSHIBA TEC representative).
#123000
#
#/CID