Instruction Manual

G-4 User’s Manual
TECRA R10
7. Lift the plastic film and clean the cooling module using a vacuum
cleaner or other cleaning tool.
Figure G-2 Lift the plastic film
8. Seat the Cooling module cover back into place on the computer to
reattach.
9. Secure the Cooling module cover with one screw.
10. Install the battery pack (refer to the Replacing the battery pack section
in Chapter 6, Power and Power-Up Modes, if required).
11. Turn your computer over.
Do not use a ball pen, cotton swap or similar to remove dust. If these touch
the inside of the computer, it could be damaged or become clogged,
leading to further problems.
Plastic film