Installation and Operation Manual

- 19 -
(1) When the spring is released -
Perform the steps shown in Figures 25 and 26 in that order.
(2) When the spring is taut -
Perform the step shown in Figure 27 in that order.
Figure 25 Turn the handle clockwise 3 to 5
times and make sure that the spring status
is taut.
Figure 26 Press the closed lever (green) in
the direction of the arrow to close the
circuit. When the switching status will
change to ON, the VCB is set in close
state.
Figure 27 Press the closed lever (green) in
the direction of the arrow to close the
circuit. When the switching status changes
to ON, the VCB is set in the closed state.
CLOSED
LEVER
CLOSED
LEVER
CHARGING
HANDLE