Manual

_ INTRODUCTION

Before Using the Remote

Control

With this Remote Control, you can operate your "IV and most VCR and cable box models regardless of the

manufacturer. However, this Remote Control must first be programmed to control other VCR and cable box brands.

See page 13.

If you have a TOSHIBA VCR, your Remote Control has already been programmed for you.

Before attempting to operate your Remote Control, install the batteries according to "To install the batteries" below.

Notes:

• After installing newt_atteries, the Remote Control will set itself to the codes for TOSHIBA TVs and VCRs. If you are

using the Remote Control to operate other manufacturer's equipment, you will have to reprogram those codes.

• This Remote Control may have functions not available on your VCR and cable box remote controllers.

These functions may or may not operate your VCR or cable box, Refer to the owner's manuals supplied with the

equipment to see which functions are available.

• The remote controller supplied with your VCR or cable box may have keys not duplicated on this Remote Control. If

you want to usethese functions, please use the original remote controller.

To instafl the batteries

Place the Remote Control face down and remove

the battery cover.

Pressand slide

_to ramova.

o fl

CAUTIONS

• Do not throw your batteries into a fire. Dispose of

your batteries in a designated disposaJ area.

• Do not combine used batteries with new ones.

• Do not mix battery types.

Tips for best operation

Insert two "AA" size batteries, matching the + and

- signs on each battery with the + and - signs in

the battery compartment.

• For optimum performance, aim the Remote Control

directly at the TV from a distance within 16 feet (5 m),

and be sure there is no obstruction between the

Remote Control and the TV.

• If your Remote Control does not always operate the

"IV as you wish, you probably need to replace the

batteries.

• If the Remote Control will not be used for a long

period of time or when the batteries are worn out,

remove the batteries to prevent leakage.

• Do not drop, dampen or disassemble the Remote

Control.

Slide the battery cover shut until the lock clicks.