Manual

_ INTRODUCTION

Programming the Remote

Control

POWER

TOaHIBA

For future reference, write the code

number you set,

VCR CODE:

CABLE CODE:

Note:

You have to reprogram the Remote

Control when you change its batteries.

• This Remote Control is programmed to operate TOSHIBA VCRs.

• To operate VCRs (or Cable converters) other than TOSHIBA models,

perform the following procedures before operating.

Refer to the "VCR code table" (or "Cable TV converter code table _)

on pages 14 and 15 to find the code number that corresponds to the

brand name of your VCR (or your converter),

If more than one number is listed, try eachone separately until you

find the one that works.

Set the TV/CABLE/VCR switch to "VCR" (or "CABLE").

While holding down RECALL,press the Number buttons to enter

the three digit code number for your brand of VCR (or converter).

Point the Remote Control at the VCR (or at the converter) and press

POWER to test the code number.

the number is correct, the VCR should turn on.

_lf the VCR does not respond to the Remote Control, repeat steps

1 through 4 with another code number.

Reset the TV/CABLE/VCR switch to "'IV" to control the TV.

Notes:

• Some newer VCRs are capable of working on either of two remote

codes. These VCRs have a switch labeled "VCR 1/VCR 2."

If your VCR has this kind of switch, and does not respond to any of

the code numbers for your VCR brand name, set the switch to the

other position ("VCR 1" or "VCR 2") and reprogram the Remote

Control.

• In some rare cases, you may not be able to operate your non-

TOSHIBA equipment with the supplied Remote Control. This is

because your equipment may use a code that is not provided with

this Remote Control. In this case, please use the equipment's own

remote control.