Operation Manual

30 Basic Operations
Making a Call
1. Confirm that the power is on.
Confirm that the signal level is sufficient.
2. In standby mode, enter a phone number.
If you enter the wrong number, each press of (Clear) deletes the digit on the far
right.
To enter  , P or , press and hold .
You can also make a call from the Contacts list (page 47) or the call log (page 34).
3. Press .
4. Press to end the call.
Tip
You can perform the following
operations if you press (Options)
after entering a phone number in
standby mode.
 Voice Call: Makes a voice call.
 Video Call: Makes a video call
(page 75).
 Save to Contacts: Saves the
phone number to the Contacts list
(page 48).
 Send Message: Allows you to
create an SMS/MMS message
(pages 95, 98).
Note
 You cannot make calls (except
emergency calls) if the total cost
reaches the specified maximum
call limit when the cost limit (page
34) is set to On. To make a new
call, set the cost limit to Off.
 When the cost limit (page 34) is set
to On, a call will be disconnected if
the total cost reaches the specified
maximum call limit during the call.
en_TX62.book Page 30 Wednesday, May 31, 2006 11:08 AM