Manual

77
CONTROLS AND FEATURES
English
• If the HDMI cable from connected equipment is changed,
Enable REGZA-LINK in the REGZA-LINK Setup menu may
need to be reset to On.
• If you change the HDMI lead to a connected device or
change an HDMI device setting, reset the Enable REGZA-
LINK item on the REGZA-LINK Setup menu from Off to On.
When connected equipment is switched on, REGZA-LINK will
automatically detect the television through the input
selection. If the television is in standby, it will be switched on
automatically.
These functions can be enabled or disabled from the REGZA-
LINK Setup (see page 76).
NOTE:
• Even if the equipment is showing a menu, the television
may automatically show the input source.
• This feature depends on the connected equipment and
television state.
If the television is turned off (standby mode), the television
will send a message to turn off (standby mode) all of the
REGZA-LINK devices connected to the television.
These functions can be enabled or disabled from the REGZA-
LINK Setup (see page 76).
NOTE: This feature depends on the connected equipment
and television state.
REGZA-LINK one touch play
REGZA-LINK system standby