Operation Manual

22
6
PLAYBACK PROCEDURE
Press PLAY.
The disc tray closes auto-
matically.
On the TV-screen, “ ”
changes to “Reading” and
then playback com-
mences.
•A menu screen will
appear on the TV screen,
if the disc has a menu
feature.
1
Press (OPEN/CLOSE)
on the unit or OPEN/
CLOSE on the remote
control.
The disc tray will open.
2
Place a disc onto the tray.
Position it with the printed
label side up, align it with
the guides, and place it in
its proper position.
3
Press / or / to make a selection.
4
Press ENTER.
• Title is selected and play commences.
5
Press STOP to end playback.
• The unit memorizes the stopped point, depending on
the disc. “
” appears on the screen. Press PLAY to
resume playback (from the scene point).
•
If you press STOP again or unload the disc (“ ” appears
on the screen.), the unit will clear the stopped point.
7
To stop the playback, press STOP.
Then press OPEN/CLOSE.
The disc tray opens.
Remove the disc and press ON/STANDBY.
The disc tray closes automatically and unit turns off.
NOTES:
• If a non-compatible disc is loaded, “In-
correct Disc”, “Region Code Error” or
“Parental Error” will appear on the TV
screen according to the type of loaded
disc. If these appear, check your disc
again (see pages 20 and 36).
• Some discs may take a minute or so to
start playback.
• When you set a single-faced disc label
downwards (ie. the wrong way up) and
press
(PLAY) or (OPEN/
CLOSE) on the unit, “Reading” will ap-
pear on the display for approx. 30 sec-
onds and then “Incorrect Disc” will be
displayed.
• Some playback operations of DVDs
may be intentionally fixed by software
producers. Since this unit plays DVDs
according to the disc contents the soft-
ware producers designed, some play-
back features may not be available. Also
refer to the instructions supplied with the
DVDs.
Reading
5P31101C P20-25 6/6/06, 10:09 AM22