Operation Manual

11
TIMER REC SET
AUTO REPEAT OFF
CHANNEL SETUP
TV SETUP
CLOCK SET
EXIT
ENTER
SELECT
: MENU
: ENTER
:
MANUAL CLOCK SETTING
You must set the correct time and
date on your unit before you make
Timer recordings. You should only
need to set the time manually if it was
not set during Auto Set Up.
1
Press MENU/SETUP.
Press or to select the
CLOCK SET mode, then press
ENTER.
Press or to select the
current date, then press .
• The day of the week shown
will not be correct until you
have finished entering the
month and year settings.
2
Set the month, year and hour in
the same way as in step 2.
3
NOTES:
• During a power failure, disconnection of
the mains lead or if the MAIN POWER
Switch is switched off, the clock and all
its programmed setting will re main in
the memory for 30 minutes. If the power
failure is longer than 30 minutes you will
have to reset the present time.
• If you want to correct the digits while
setting, press until the item you want
to correct is blinking, then press
or to correct the desired setting.
4
Preparation
Press TV/VCR to select TV/VCR mode.
Example:
Setting the clock to 11:30, 30 October, 2004.
Press
or to select
current minute, then press .
• You can change in 10-
minutes step by holding down
or .
CLOCK SET
DAY
MONTH
YEAR
TIME
30 FRI
1
2004
0:00
EXIT
SET
SELECT
: MENU
:/ 0
-
9
OK
:
: ENTER
AUTO TIME ON
CLOCK SET
DAY
MONTH
YEAR
TIME
30 SAT
10
2004
11: 30
EXIT
SET
SELECT
: MENU
:/ 0
-
9
OK
:
: ENTER
AUTO TIME ON
CLOCK SET
DAY
MONTH
YEAR
TIME
30 SAT
10
2004
11: 30
EXIT
SET
SELECT
: MENU
:/ 0
-
9
OK
:
: ENTER
AUTO TIME ON
5
Press or to select ON.
Your unit automatically corrects
the clock setting every hour once
you set AUTO TIME to ON.
CLOCK SET
DAY
MONTH
YEAR
TIME
30 SAT
10
2004
11: 30
EXIT
SET
SELECT
: MENU
:/ 0
-
9
OK
:
: ENTER
AUTO TIME ON
6
Press ENTER.
The time and day will be displayed.
11 : 30 SAT
5N40101B [E] P10-13 5/28/04, 15:2211