Operation Manual

14
TIMER REC SET
AUTO REPEAT OFF
CHANNEL SETUP
TV SETUP
CLOCK SET
EXIT
ENTER
SELECT
: MENU
: ENTER
:
PICTURE CONTROL ADJUSTMENTS
The picture settings have been factory
adjusted under optimum signal recep-
tion. However, conditions may not be
the same in your area. After tuning in the
unit, allow it to warm up for a few min-
utes. If the picture is not to your liking,
make the following adjustments using
the remote control.
1
To adjust the picture, press
MENU/SETUP.
Press or to select the TV
SETUP mode, then press
ENTER.
Press or to select the
PICTURE mode, then press
ENTER.
2
Press ENTER until your desired
PICTURE mode appears eg.
BRIGHTNESS, CONTRAST,
COLOUR, SHARPNESS. Then
press or to adjust the
level of the PICTURE.
(See the below for detail.)
3
After finishing the adjustment, press MENU/SETUP
repeatedly to return to normal TV screen.
4
NOTES:
• To resume the normal picture adjustment,
press CANCEL, while in the picture mode
menu.
• The picture settings can only be adjusted by
using
or and ENTER when they are
displayed on the screen.
• The On-screen display will disappear about
one minute after finishing an adjustment.
Preparation
Press TV/VCR to select TV/VCR mode.
Each time you press ENTER the picture adjustment Screen
changes as follows.
BRIGHTNESS
Press ENTER until "BRIGHTNESS" appears on the screen, then
press or to adjust the brightness. When is pressed,
the darker portions of the picture become lighter.
SHARPNESS
Press ENTER until "SHARPNESS" appears on the screen, then
press or to adjust the sharpness.
In weak reception areas, the picture may be more pleasing when
the SHARPNESS is set at a lower level.
CONTRAST
Press ENTER until "CONTRAST" appears on the screen, then
press or to adjust the contrast. Pressing improves
the contrast and enhances the colour. Picture looks sharper in the
daytime by increasing the contrast level and sharper at night by
lowering the contrast level.
COLOUR
Press ENTER until "COLOUR" appears on the screen, then press
or to adjust the intensity of the colours. This should be
set to where the colours appear normal in intensity and brilliance.
ON/OFF TIMER SET
PICTURE
NICAM
TV SETUP
EXIT
ENTER
SELECT
: MENU
: ENTER
:
AUTO
NEXT
RESET
SET
: ENTER
EXIT : MENU
: CANCEL
:
BRIGHTNESS 0
5N40101B [E] P14-23 5/28/04, 15:2214