Operation Manual

13
CH 2
MUTE
TV OPERATION
1
Press ON/STANDBY. Then press TV/VCR to select TV/VCR
mode.
Press Direct Channel Selection.
2
The VOLUME can be adjusted to
a desired level by pressing VOL
+ or –. The VOLUME control is
represented by a green bar on
the screen.
3
Press one of keys 1-9
as required.
Press the two digits in
order from left to right.
1-9:
10-80:
VOLUME 32
VIDEO Plus+/PROG.
To cut off the sound, press this
button once. The unit will be
silenced and the symbol “MUTE”
will appear on the screen. The
muting can be released by
pressing MUTE again or VOL + / –.
Press and release CH/PAGE
or .
For channels to change properly,
they must be tuned into the unit
memory.
Press DISPLAY. The current time, channel number, real time
tape counter, tape speed and VCR operation will be indicated.
Press DISPLAY again to remove the call display.
This button allows you to go back to the last channel selected by
pressing CHANNEL RETURN. Press this button again to return
to the last channel you were watching.
Current time
VCR operation
Channel No.
Real Time Tape Counter
Auto Repeat
Tape In
Tape Speed
TV/VCR mode or DVD mode
USING CH/PAGE OR BUTTON
MUTE
DISPLAY
CHANNEL RETURN
NOTES:
• If SLEEP is pressed when the unit is the
REC mode, the clock will count down and
the picture will shut off at the set time, but
the recording continues.
• If the station being viewed stops
broadcasting, the TV will shut off after 15
minutes.
To set the TV to turn off at a set time,
press SLEEP on the remote control.
The clock will count down 10 minutes
each time the button is pressed in
the order of 120, 110.....20, 10, 0.
After the sleep time is programmed,
the display will disappear and will
reappear every 10 minutes. To
SLEEP
SLEEP
90
confirm the sleep time setting, press SLEEP once and the
remaining time will be a momentarily displayed. To cancel the
sleep time, press SLEEP repeatedly until the display turns to 0.
5N50301A [E] P10-13 1/7/05, 4:50 PM13