Operation Manual

23
EXIT
SELECT
: MENU
/ ENTER:
15 FRI 17 : 30
18 : 00
SP8
:
:
:
:
:
:
:
:
:
:
:
:
:
:
PLUSCODE NO. 57378
----
DATE
START
END
CH
SPEED
15 FRI
8
SP
PDC OFF
17: 30
18: 00
EXIT
SET
SELECT
: MENU OK : ENTER
:
:
PLUSCODE NO. 57378
----
DATE
START
END
CH
SPEED
15 FRI
8
SP
PDC OFF
17: 30
18: 00
EXIT
SET
SELECT
: MENU
:/ 0
-
9
:
OK : ENTER
PLUSCODE NO. 57378
----
ONCE
DAILY
WEEKLY
EXIT
OK
CLEAR
PLUSCODE NO.
SELECT
: VIDEO PLUS
+
: ENTER
: CANCEL
:
: 0
-
9
VIDEO PLUS+ TIMER RECORDINGS
1
To turn “ON” the unit, press ON/STANDBY.
Press TV/VCR to select TV/VCR mode.
Load a cassette tape with the
erase prevention tab intact.
2
Press or to select Once, Daily or Weekly.
Single programme Once
Everyday Daily
Same day every week Weekly
VIDEO Plus+/PROG.
Your unit is equipped with VIDEO Plus+. This
“automatic” system greatly simplifies timer
programming because you do not have to enter the
usual information such as date, channel, start and
end times. By keying in the PlusCode for the TV
programme you wish to record (listed in most TV
guides) all the relevant information is set for you.
VIDEO Plus+ recordings allow you to easily
program your unit so that it will record at preset
times. The built in timer allows unattended
recording of up to 8 programmes within 1 month.
VIDEO Plus+ and PlusCode are registered
trademarks of Gemstar Development
Corporation.
The VIDEO Plus+ system is manufactured under
license from Gemstar Development Corporation.
Press PROG..
The VIDEO Plus+ screen will
appear on the TV screen.
Enter the PlusCode for the TV
programme you wish to record
using the number buttons (0-9).
3
Press ENTER. If an incorrect
number is entered the word
ERROR will be displayed and you
will have to re-enter the correct
number. The VIDEO Plus+ screen
on the TV will show the date, start
and end times for your recording.
If you want to change the setting,
press
or to select the item and press or to change
to the desired setting.
4
Press to select the SPEED.
Press
or to select either
standard (SP) or Long (LP) play.
Press
to confirm the speed.
Press
or to select PDC ON
or OFF (please see the
explanation of PDC at the step 5
of page 24).
5
When you have finished setting
your recording press ENTER to
complete your programming. You
can confirm your programming. If
you wish to set further VIDEO
Plus+ recordings, press PROG.
three times to return to the VIDEO
Plus+ screen and repeat stages 3-6.
Press MENU twice to remove the display.
6
Press TIMER REC to set your timer
recording. Your unit will go into
timer record mode.
The
REC indicator will light on
the front of the unit.
If you do not put your unit into timer
record mode your recording will not take place.
Your TIMER RECORDING is now set.
At the set time your unit will record your programme then
go back into timer record mode.
7
5N50301A [E] P14-24 1/7/05, 4:51 PM23