Manual

nections
....:afore you use this VCR, it is necessary to connect it to your TV. Several ways of connecting are
available depending on your use of TV or cable box. Select one which is applicable to your equipment.
Disconnect the antenna cable from your TV and connect it to the RF IN terminal on the
VCR.
Connect the RF OUT terminal to the TV.
VHF/UHF _ _ VHF antenna_ "_"
combination antenna _._.,J only 1
•
UHF antenna
only
"8
rrl
5
z
Setting the VCR Output Channel
When the VCR is connected in this way, the VCR sends the output
signals to channel 3 or 4 on your TV. Set the output channel
selector (CH selector) of the VCR to "3" or "4", whichever is vacant
in your area.
(not supplied)
The AUDIO/VIDEO jacks are also available to connect your TV.
When connected I/our TV using the
AUDIO/VIDEO OUT jacks
_LLINEOUTVIDEO VIDEOIN D
LINE OUT AUDIO AUDIO IN
To watch video pictures, set the video input mode
on your TV. For the video input mode, refer to the
manual of your TV.
Choose one of the below according to your usage of the cable box.
This set-up will enable you to:
J
Incoming cabl! l
- record an unscrambled channel.
- watch an unscrambled channel while recording it.
- record an unscrambled channel while watching
another (only when you connect a cable-
compatible TV).
You will need to:
• select TV channel 3 or 4 to receive video signals.
• to record a channel while watching another, press
TV/VCR on the remote control to turn off the
"VCR" indicator in the VCR display and select a
desired channel on the TV (only when you connect
a cable-compatible TV).
11