Manual

Satellite Receiver Set-up

.....VCR can directly control channel selecting of the connected DSS ®satellite receiver.

DSS ® Satellite Receiver Control

This VCR needs to be connected to a DSS ®

satellite receiver equipped with an infrared

wireless remote control. You can select

satellite channels from the DSS ®satellite

receiver by operating this VCR.

DSS ®is registered trademark of DIRECTV,

Inc., a unit of GM Hughes Electronics.

It is also possible to automatically change

the satellite channels according to your

program setting in the timer program

recording.

Placing the DSS ®Satellite

Receiver

Put the DSS ®satellite receiver on the top of

the VCR as shown below. Do not block the

sensor window.

DSS ®satellite receiver

The infrared signals come out of the sensor

window and received by the DSS® satellite

receiver. The VCR sends out infrared

signals to your DSS ®satellite receiver even

during timer program recording.

Notes

• If the channels cannot be controlled properly

because the infrared signal fails to reach the DSS ®

satellite receiver, change the position of the

receiver on the VCR so that it can receive the

signal.

• Keep the DSS ®satellite receiver turned on even

while the VCR is in the timer program recording.

Connection Type

T_,peA

Satellite

antenna

I o::

DSS®satellite receiverl_ RFIN1

T cpe B

Satellite

antenna Incoming cabl_

_DSS ®satellite receiver

I _ B;II e I

LINE OUT l_b_ _