User's Manual

ManualsBrandsToshiba ManualsRemote ControlToshiba WH-H1JE2

Wireless Remote Controller Kit

Owner’s Manual

–12–

10 ADDRESS

When two or more indoor units controlled by the same wireless remote controller are

installed in a room, a unique address can be set for each indoor unit to prevent

interference.

Up to 6 indoor units can be controlled independently by the remote controller by

matching the address switch setting of the signal receiving part with the address

displayed on the remote controller. The signal receiving part (inside the ceiling panel

or indoor unit) has address switches for receiving addresses, and the remote

controller has an address button for transmitting addresses.

For details, contact the dealer from whom you purchased the air conditioner.

 Checking Addresses

Push on the remote controller. The current address appears on the display.

When this address equals the address of the address switch in the signal receiving part

(inside the ceiling panel or indoor unit), the buzzer sounds. When the address on the display

is “ALL,” the buzzer sounds and the remote controller is enabled regardless of the address

switch setting in the signal receiving part.

Transmit signals while pointing the remote controller at the signal receiving part of the indoor

unit to be controlled.

 Matching Addresses

Address setting on the remote controller

1. Push for at least 4 seconds. “Address” lights up on the display and the current address flashes.

2. Each time you push , addresses change cyclically like ALL → 1 → 2 → 3…→ 6 → ALL. Select

an address that matches the address switch setting in the signal receiving part of the indoor unit to

be controlled.

3. Push . The flashing address changes to lighting and is displayed for 5 seconds. When this

address equals the address switch setting in the signal receiving part, the buzzer sounds.

Address displayed on

the remote controller

(The location of is

shown on page 3.)

Address Address Address

Address

Address switch setting

in the signal receiving

part (inside the ceiling

panel or indoor unit)

* Any setting is

OK.

Set S001 to the right position (for addresses 1, 2, and 3) or to the left

position (for addresses 4, 5, and 6).

Set S002 to the right position (for addresses 1 and 4), to the center (for

addresses 2 and 5), or to the left position (for addresses 3 and 6).

ADR

12-EN

EH78981901_01EN_remo_OM.book Page 12 Saturday, November 10, 2007 4:26 PM