User's Manual

Wireless Remote Controller Kit
Owner’s Manual
–5–
 Display section
All inticators are shown in the right and the lower figures for the
explanation.
Only selected contents are display in actual operation.
• When turning on the leak breaker at the first time, [SET DATA]
flashes on the display part of the remote controller.
While this display is flashing, the model is being automatically
confirmed.
Accordingly, wait for a while after [SET DATA] display has
disappeared, and then use the remote controller.
1 Transmitting indication
Displayed while operating the switches of the
remote controller.
2 Mode display
The selected operation mode is displayed.
3 Fan mode select display
The selected fan mode is displayed.
4 Filter display
If “FILTER ” is displayed, clean the air
filter.
5 CHECK display
Displayed while the protective device works
or a trouble occurs.
6 Set up temperature display
The selected set up temp. is displayed.
7 Louver position display
Displays louver position.
8 SWING display
Displayed during up/down movement of the
louver.
9 Timer time display
Time of the timer is displayed.
(When a trouble occurs, the check code is
displayed.)
10 Timer SET IN setup display
When pushing the Timer SET IN button, the
display of the timer is selected in order of
[OFF] → [OFF] repeat OFF timer
→ [ON] → No display.
ADR
SENSOR
ADR
ACL
Display
section
Operation
section
ADR
1
2
3
4
5
6
7
2
10
8
(AUTO)
(HIGH)
(MED.)
(LOW)
5-EN
EH78981901_01EN_remo_OM.book Page 5 Saturday, November 10, 2007 4:26 PM