User's Manual
35
CONTROLS AND FEATURES
English
Input selection and AV
connections
Defining the INPUT and OUTPUT sockets so that
the television recognises connected equipment.
See page 8 for a clear view of the back connection
recommendations.
Most media recorders and decoders send a signal through the
SCART lead to switch the television to the correct
Input
socket.
Alternatively press the external source selection button
o
until the picture from connected equipment is shown.
This button must be used to view equipment connected using
the COMPONENT VIDEO INPUT (
EXT3
).
An
S
in the display
e.g.
o
2S
(
EXT 2S
), indicates the input is set
for an S-Video signal.
Use the Input Selection if the television does not switch over
automatically.
a
At any time by pressing
o
a list will appear on screen
showing all stored programmes and external
equipment. Use
B
and
b
to highlight and
Q
to
select.
NOTE:
When in
digital
mode
ATV
cannot be
selected, in
analogue
mode
DTV
cannot be selected.
To switch between
DTV
and
ATV
press the
ATV/DTV
button.
HDMI™ displays equipment connected to
Input HDMI
on the back of the television.
PC displays a computer connected to
Input RGB
/
PC
on
the back of the television.
This specifies the type of signal going into SCART 2 (
EXT2
) on
the back of the television. Please refer to the manufacturers
instructions for the connected equipment.
a
In the
SET UP
menu press
b
until
AV connection
is
highlighted, then press
Q
.
b
With
C
or
c
select either
AV
or
S-VIDEO
as the
required
input
for
EXT2
.
If the colour is missing try the alternative setting.
Input selection
HDMI2
HDMI1
1
2
3C
ATV
PC
HDMI3
DTV
INPUT signal selection
1/2
OK
OK
OK
OK
MENU EXIT
SET UP
Language English
Country UK
Auto tuning
Manual tuning
AV connection
Picture position
Back Watch TV
MENU EXIT
AV connection
PC/HDMI1 audio PC
HDMI1 audio Digital
EXT2 input AV
Woofer Internal
Back Watch TV
Lip Sync On
00GB_XV555D_Euro_kai.book Page 35 Tuesday, September 2, 2008 7:01 PM