User's Manual

Picture 5.

Picture 6.

LOCK 200 USING THE RUBBER FEET

Rubber feet included in the sales package can be installed in the

bottom of the Lock for more convenient installation horizontally

e.g. on a table.

See picture 5 and 6 for the mounting.

LOCK 500 INSTALLATION ON THE TABLE

The Lock can be placed standing vertically on its rubber feet. There

are vent holes on both sides of the device, designed to provide

cooling air passing through the device. Allow enough free space,

minimum of 25mm around the Lock to ensure the free flow of

cooling air.

Make sure there is no risk of the device falling aside as this

would block the cooling air flow through the vent holes. Have all

the cables secured in such a way that they cannot make the Lock

fall aside and routed as far away from the antennas as possible.

Position the antennas in orthogonal pattern, i.e. in such a way that

they form 90 degrees angle between each other.

Observe the gender of the antenna connectors to make sure each

antenna is fitted into the correct antenna port. To achieve the

maximum radio performance, follow the antenna pattern shown in

Picture 7.

Avoid installing the Lock close to other high-power radio

transmitters as they may affect the performance of the Lock. Also

avoid installing the Lock close to any sensitive devices that may be

affected by the antenna signals emitted by the radio transmitter

of the Lock. In case of unwanted disturbance, relocate the cables

and/or the Lock in a place where the devices do not disturb each

other.