User's Manual

LOCK 500 INSTALLATION TO DIN RAIL

The Lock can be installed to DIN rail by using the integrated DIN rail

bracket located in the backside of the device. Follow the sequence

shown in picture 7.

Removal is the reverse of installation. There are vent holes on both

sides of the device, designed to provide cooling air passing thru

the device. Allow enough free space, minimum of 25mm around

the Lock to ensure the free flow of cooling air. Route and secure

all cables as far away from the antennas as possible. Position the

antennas in orthogonal pattern, i.e. in such a way that they form

90 degrees angle between each other. Observe the gender of the

antenna connectors to make sure each antenna is fitted into the

correct antenna port.

To achieve the maximum radio performance, follow the

antenna pattern shown in Picture 7. Installing the Lock inside

of metal cabinet may result in the degradation or loss of radio

performance. In such case have the antennas installed outside of

the cabinet using coaxial RF extension cables, available at your

local specialized dealer or service technician.

Avoid installing the Lock close to other high-power radio

transmitters as they may affect the performance of the Lock. Also

avoid installing the Lock close to any sensitive devices that may be

affected by the antenna signals emitted by the radio transmitter

of the Lock. In case of unwanted disturbance, relocate the cables

and/or the Lock in a place where the devices do not disturb each

other.

Picture 8. Lock 500i installed

to DIN rail. See the antenna

directions.

1. Place the DIN-rail

bracket slider under

the lower edge of the

DIN rail.

Picture 7.

2. Push the Lock

upwards until the

slider travel is in

the end

3. Push the upper

edge of Lock parallel

to the wall

4. Slide the Lock

down and check that

the DIN rail bracket

has a firm grip of the

DIN rail