User's Manual

LOCK 500

A power source with voltage of 12-48V DC +/-20% is required

to operate the Lock. The power input port is equipped with a

removable plug-in connector included in the sales package.

Remove the connector if needed and connect the stripped power

wires by tightening the wire connector screws with a flat blade

screwdriver.

A device frame connection is available at the power input

port. It is recommended to wire this connection to the installation

cabinet protective earth potential with as short cable as possible.

This will enhance the immunity of the equipment against conducted

and radiated RF disturbance, as well as against electrical

transients that may be propagated by the ethernet cables. Use

+ and - terminals to power the device. Follow the polarity and

grounding symbols in the front panel.

Make sure the connector is completely plugged in and secure the

connector into the Lock frame by tightening the locking screws

with a flat blade screwdriver. The wires with a cross-section of up

to 1.5mm

(AWG 16) can be used with the connector. The stripping

length of the conductor is 6 mm.

The Lock is equipped with a 2 Amp internal fuse. In case of a device

malfunction, the fuse is blown to protect the power circuitry. The

fuse cannot be replaced by the user. In case of a blown internal

fuse, do not open the device. Instead, contact your local Tosibox

distributor for service.

LOCK 500*PS

In addition to the powering options for Lock 500, an AC adapter

included in the Lock500*PS-version sales package may be used.

The AC adapter is supplied with interchangeable plugs that makes

it possible to connect to different electrical outlets. Select and

fit the plug that complies with your local requirements. The AC

adapter DC output connector is coaxial. Therefore, a conversion

cable is necessary to convert from coaxial DC connector to

stripped wires required by the Lock power input connector. The

conversion cable is included in the Lock500*PS-version sales

package. Follow the same procedure as with Lock 500 powering

options.